Publicité
Liens rapides
Publicité
Sommaire des Matières pour naturaled LED Wall Pack 38W
- Page 1 LED Wall Pack 38W/60W/80W with photocell TWP 38W/60W/80W EVA Gasket WWW.naturaLED.com...
- Page 2 LED Wall Pack 38W/60W/80W with photocell Open the fixture with the 4mm hex key (Allen wrench). Abra el accesorio con la llave hexagonal de 4 mm (llave Allen). Ouvrez le luminaire avec la clé hexagonale de 4 mm (clé Allen).
- Page 3 LED Wall Pack 38W/60W/80W with photocell Glue this part, align it with the mounting Glue this part position.Pass the input wire through the gasket and the hole of part B. Pegar esta pieza y alinearla con la instalación.Pon la línea de entrada por el agujero de la arandela y la pieza B.
- Page 4 LED Wall Pack 38W/60W/80W with photocell Optional installation -4 Use M4*30 screw and M4 gasket to fix the housing on the wall. La carcasa exterior se fija en la pared con tornillos M4 * 30 y cojines M4. Le boîtier est fixé au mur avec des vis (3)M4*30 screw M4 * 30 et des joints M4.
- Page 5 LED Wall Pack 38W/60W/80W with photocell Check the hinge to properly mount part A onto part B. Compruebe la bisagra para montar correctamente la pieza A en la pieza B. Vérifiez la charnière pour monter correctement la pièce A sur la pièce B.
- Page 6 LED Wall Pack 38W/60W/80W with photocell Connect Photocell Function Open the fixture. Abre la abrazadera. Ouvre la serrure. Photocell Photocell terminal Remove the installation sleeve, and then connect the photocell terminal into the photocell. Retire el manguito de instalación y luego conecte el Insulation sleeve terminal de la fotocélula en la fotocélula.
- Page 7 LED Wall Pack 38W/60W/80W with photocell Install the Sensor (2)M4*6 screw Sensor Open the fixture and put the sensor into it. Lock the sensor with M4*6 screws. Abra la abrazadera y ponga el sensor en ella.Bloquear el sensor con tornillos M4 * 6.
- Page 8 LED Wall Pack 38W/60W/80W with photocell Install the Sensor Wiring diagram Insert the probe connection into Microwave Motion Sensor the sensor. Connect the wire White Sensor L N N L' according to the wiring diagram. Conecte la sonda al sensor.
- Page 9 LED Wall Pack 38W/60W/80W with photocell Install the Emergency Driver Open the fixture with the 4mm hex wrench. Llave de 4mm seis ángulos. Ouvre la serrure avec une clé à 4mm six angles. (2)M4*6 screw Emergency driver fixed plate Lock the emergency driver fixed plate on the shell with M4*6 screws.
- Page 10 LED Wall Pack 38W/60W/80W with photocell Install the Emergency Driver (4)M4*6 screw Put the emergency driver and driver in the The hole of 15W emergency driver installation. fixture, lock it with M4*6 screws according The hole of to the suitable hole.
-
Page 11: Wiring Diagram
LED Wall Pack 38W/60W/80W with photocell Install the Emergency Driver Wiring diagram Black Black AC L Black LED- LED Fixture power supply Switch White AC N LED+ DRIVER+ DRIVER- Black LED- Emergency driver White LED+ BATTERY+ BATTERY Black Yellow/Green BATTERY-...