Block Diagram - Kustom Ardent 12M Manuel Du Propriétaire

BACK PANEL DIAGRAM
This switch uses the internal matching transformer to select the impedance of your Ardent™
12M. It does not affect speakers plugged into jacks (
output will drop 3dB when switched to 16 ohms. This is because the load on the amplifier
driving the Ardent™ 12M is ½ that of the 8 ohm setting.
This Multi-position switch uses the internal matching transformer to attenuate (lower) the
volume of the Ardent™ 12M. It does not affect speakers plugged into jacks (
reduces the amplifier load.
These 1/4" jacks are used to connect the speaker cabinet to an amplifier, such as a
powered mixer or power amp. These jacks are wired in parallel, so they can be used to
connect to another speaker cabinet.
This jack accepts Neutrik Speakon® connector. Pins +1 and - 1 are used. This jack is also
wired in parallel with the 1/4" jacks ( ).
Speakon Jacks
+1
-1
1/4" Jacks

Block Diagram

Attenuator
8 - 16 Ohm
Selector
). NOTE: The speaker acoustical
Horn
Protection
Crossover
4
). It also
Horn
Speaker
+
-