Ceiling Mounting - Dedicated Micros Dennard 2060 Manuel D'installation

6. Ceiling Mounting

Fig.5 Ceiling hole pattern
Cut/drill hole pattern in ceiling as shown in (fig.5) (Note: fixings for hole (A) are not supplied by
Dedicated Micros due to the variation of ceiling materials / thicknesses found on site. Use suitable
M6 fixings, with countersunk head, for your application.) Attach mounting disc (B) to ceiling with
chosen fixings and screw 4 off M6 x 16 soc cap hd. screws supplied into bushes as shown (C).
Attach transfer disc (E) to top of dome enclosure (G) with 4 off M6 dome hd. self tapping trilobular
screws (D) pre-fitted (fig.6) (Note: Fit safety bond bracket (F) as shown) Offer dome enclosure to
ceiling mounting disc (fig.7) engaging the screw heads (C) into keyhole slots (G). Twist to locate
and tighten fixings (C) to secure.
Please ensure safety bond is fitted as descibed on sheet 4.
D
E
G
Fig. 6
Dennard 2060 Operation Manual
A
4 x Ø6.5mm
C
B
D
F
Fig. 7
G
Page. 5