habitat et jardin Solar 1491-121333 Mode D'emploi page 10

ASSEMBLY INSTRUCTIONS
Step 4
Load tank housing onto post, slide tank housing down.
Step 5
Remove the 4 pcs preassembled stainless steel bolts (DD)
from the burner assembly (C).
Insert the gas hose from the top end of the post (F), then
attach the burner assembly (C) to post (F) using the four
bolts removed at the beginning of this step.
Tighten bolts securely.
Hardware Used
Step 6
WARNING: Remove protective cover before
assembling.
Note: Necessary for proper alignment of
reflector sections.
Attach 3 pcs reflector panels (A) to center reflector
(B) using 9 pcs Screws M6x10 (II) and 9 pcs cap
nuts (JJ).
Fully tighten all of the screws.
Hardware Used
x 4
A
B
x 9
x 9
Page 10
JJ
II II
2022-2023