Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Preset 1 on-off
on = on
oFF = off
Permanent signal of output 1,
activated at count value M
preset 1*
Permanent signal of output 1,
will become passive at count
value M preset 1**
Timed signal of output 1, will be-
come passive at count value =
preset 1**
Timed signal of output 1, activa-
ted at count value = preset 1*
Duration of timed signal of output
1, can be set from 00.01 s to
99.99 s.
* Activation of relay coil resp.
optocoupler when reaching the
preset value
** Relay coil becomes dead
resp.optocoupler will be locked
when reaching the preset value
Permanent signal of output 2,
activated at count value M
preset 2*
Permanent signal of output 2,
will become passive at count va-
lue M preset 2**
Timed signal of output 2, will be-
come passive at count value =
preset 2**
Timed signal of output 2, activa-
ted at count value = preset 2*
Duration of timed signal of output
2, can be set from 00.01 s to
99.99 s.
* Activation of relay coil resp.
optocoupler when reaching the
preset value
** Relay coil becomes dead resp.
optocoupler will be locked when
reaching the preset value
14
7. Programming of the Preset Value:
After pressing one of the arrow keys, the leading zero
blanking will be suppressed for approx. 4 seconds and
the least significant digit of the preset value flashes with
a frequency of 1 Hz.
The value of the flashing digit can be increased by using
the
-key. With the
key it will be changed to the next di-
⁄
¤
git. If no key is pressed for 4 seconds, the leading zero
blanking will be activated automatically again.
In operating mode Impulse Counter and Frequency Me-
ter the new value will be taken over now.
Setting Preset 1
Setting of the 5th decade
Setting Preset 2
Setting of the 6th decade
7.1 Setting of the sign
Select the sign by using the
key. The sign will start to
¤
flash now and can be assigned to the preset value resp.
eliminated by using the
-key. If no key is pressed for 4
⁄
seconds, the leading zero blanking will be activated au-
tomatically again. Preset value and count value are dis-
played now with the corresponding sign.
Caution! In case of automatic resets no negative values
are to be set for preset 2.
Setting the sign for preset 1
Publicité
Table des Matières
