Whirlpool WHAD501AW Guide D'utilisation Et D'entretien page 8

TROUBLESHOOTING
Before calling for service, try the suggestions below to see whether you can solve your problem without outside help.
Dehumidifier will not operate
The power supply cord is unplugged. Plug into a grounded
■
3 prong outlet. See "Electrical Requirements. "
A household fuse has blown, or circuit breaker has tripped.
■
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician. See "Electrical Requirements. "
The Power button has not been pressed. Press POWER.
■
The local power has failed. Wait for power to be restored.
■
Water bucket is full. Empty bucket.
■
Water bucket is not completely installed. Make sure the water
■
bucket is properly installed.
Dehumidifier blows fuses or trips
circuit breakers
Too many appliances are being used on the same circuit.
■
Unplug or relocate appliances that share the same circuit.
Time-delay fuse or circuit breaker of the wrong capacity is
■
being used. Replace with a time-delay fuse or circuit breaker
of the correct capacity. See "Electrical Requirements."
You are trying to restart the dehumidifier too soon after turning
■
off the dehumidifier. Wait at least 3 minutes after turning off
the dehumidifier before trying to restart the dehumidifier.
NOTE: A damaged power supply cord must be replaced with a
new power supply cord obtained from the product manufacturer
and must not be repaired.
Dehumidifier seems to run too much
The dehumidifier is in a room with very high humidity levels, or
■
is too small for the room.
8
Ice forms on coils
The dehumidifier features an automatic defrost mode that will
■
shut off the compressor and allow the fan to run. This reduces
the ice buildup on the coils. The compressor will cycle back
on when the defrost sensor senses the correct operating
conditions.
The temperature of the room is too cold. Raise the room
■
temperature or move the dehumidifier to a warmer location.
Fan runs but dehumidifier is not
removing moisture
The dehumidifier features an automatic defrost mode that will
■
shut off the compressor and allow the fan to run. This reduces
the ice build-up on the coils. The compressor will cycle back
on when the defrost sensor senses the correct operating
conditions.
The filter is dirty. Clean the filter.
■
Error codes in display
If E1 or E2 appears in the display, call for service.
■
If LO appears in the display, the temperature in the room is too
■
cold. Increase the room temperature or move the dehumidifier.
If HI appears in the display, the temperature in the room
■
is too warm. Decrease the room temperature or move the
dehumidifier.
Normal Operating Sounds
When your dehumidifier is operating normally, you may hear
sounds such as:
Droplets of water hitting the condenser, causing a pinging or
■
clicking sound. The water droplets help cool the condenser.
Air movement from the fan.
■
Clicks from the thermostat cycle.
■
Vibrations or noise due to poor wall or window construction.
■
A high-pitched hum or pulsating noise caused by the modern
■
high-efficiency compressor cycling on and off.