SPOTTUNE W1-F-B Mode D'emploi page 11

Volume control
The volume level of Spottune SUB can be adjusted either through Spottune Cloud, or
•
manually by using the "Volume buttons" on the back of the subwoofer.
Factory Reset
Press "Zone button" on Spottune SUB and hold for 30 seconds to factory reset the sub-
•
woofer. The "Status LED" will flash yellow to confirm the reset.
Mounting : Wall
WHEN INSTALLING, ALWAYS OBSERVE THE NATIONAL INSTALLATION AND ACCI-
WARNING
DENT PREVENTION REGULATIONS
DO ALL SETTINGS ON REAR PANEL, BEFORE MOUNTING SUB TO ITS PLACE.
NOTE:
Using
wall anchors, (see minimum requirements below), and mount the screws in the
wall. Mount the SUB by placing the premounted wallbrackets on the screws. Make
sure the subwoofer is mounted solid. Thighten screws if necessary.
Minimum requirements for wall mounting:
Anchors: suitable for wall, minimum requirement 10 kg per anchor
Screws: minium requirement 10 kg per screw
the mounting template, place and mark up holes. Find suitable screws and
11
*Screw/anchors
are not included