Completing Installation - Swann DB-815 Consignes D'installation Et D'utilisation

Completing Installation

All that's left to do is attach power to the system, and to mount the indoor and
outdoor units on the brackets which have already been placed.
To attach power:
• Attach the plug on the end of the supplied 12V power supply to the plug on
the rear of the indoor unit.
• Plug the power supply into a wall socket. If necessary, turn the wall socket
on.
• The system should now have power.
• It is not necessary to separately connect power supply to the outdoor unit, as
power is supplied from the connection to the indoor unit.
Attaching the Units to the brackets:
Indoor:
• The indoor Unit is simply placed over the mounting bracket so that the top
clasps fi t in the holes in the rear of the unit.
• Push down to lock the unit in position.
Outdoor:
• The outdoor unit should insert into the outdoor unit, clipping into position
when pressed back and up.
• To secure it fi rmly and to prevent tampering, the outdoor unit can be screwed
into position.
• To do so, remove the round soft rubber plug on the bottom of the outdoor
unit.
• When the unit is in the correct position (ie. inserted fully into the bracket)
insert the supplied smaller screw into this hole and tighten.
• Re-apply the rubber plug to prevent unwanted moisture/water entering the
unit.
Using more than one indoor unit:
You can connect a second indoor unit to the Intercom system. You'll need to
purchase the second unit in addition to the current kit.
The second unit is wired in parallel with the fi rst: that is, terminal 1 from the
outdoor Unit should be wired to terminal 1 on the fi rst monitor which, in turn, is
wired to terminal 1 of the second unit. Repeat for connections 2 ~ 4.
8 8 8