Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
UNITOR HPC 54/1 67/1
5.2
Some typical cleaning tasks
Task
Cleaning of
walls, floors and
equipment.
Detergents
Machinery
5.2.2
Task
18
All manuals and user guides at all-guides.com
Accessories
1. Soaking – apply foam to all surfaces (bottom to top)
Injectors
and wait for approx. 10 - 30 minutes.
Foam lance
2. Remove the dirt from surfaces with the high
Powerspeed lance
pressure lance or chosen accessory. Again, clean
Floor Cleaner
from bottom to top on vertical surfaces.
3. To flush away large quantities of dirt, change to low
pressure mode and use the higher flow to push
l
away the dirt.
4. Use recommended disinfectant products and
methods to ensure hygiene. Apply
disinfectant once the surfaces are perfectly clean.
Detergent injection
1. Apply detergent to vehicle or equipment surfaces in
Powerspeed lances
order to soften up dirt and grime. Apply from bottom
Curved lances and
to top.
underchassis washers
2. Proceed with cleaning using the high pressure
Brushes
lance. Clean again from bottom to top. Use
accessories to clean in difficult to reach places.
3. Clean fragile areas such as motors, rubber at lower
pressure levels to avoid damage.
Accessories
Method
Method
Options / model variants
1)
Original instructions
Publicité
Table des Matières
