Contech CatStop Mode D'emploi

CatStop
Lens
Speaker
3
Installing Battery or Power Adapter
Battery:
1. Remove the battery door.
2. Install a new 9 volt alkaline battery.
3. Close the battery door.
Power Adaptor:
1. Plug AC Adaptor into an outlet
2. Plug power jack into the CatStop unit.
When you first install the battery, the red
•
light will stay on for 40-60 seconds while
the unit warms up.
• The red light stays on for 3 seconds
indicating that the unit has been
triggered.
Replace the battery when the red light
•
does not come on.
6
Fixed Mounting
1. Maximum mounting height is
30 cm or 12".
2. Use the template below to locate
position of screw holes.
3. Drive in screws (provided) leaving
a 4mm (¼") gap between the
screw heads and the wall.
4. Line up screw heads with key
holes.
5. Hang the CatStop unit using the
keyholes on the back of the unit.
5 cm (1.97 Inches)
1
1. Internal sensors detect the
CatStop Unit
warm body of the cat as it
enters into the CatStop's
field of view.
Main Stake
2. The unit triggers a 3 second
ultrasonic burst of sound.
Extension Stake
3. A red light indicates
that the CatStop! unit has
Mounting Screws
been triggered.
4
Battery door cover
•
Place the CatStop so it will have a clear view of the area you
are protecting; objects in front of the unit will prevent
triggering and block sound.
•
Avoid pointing the CatStop at high traffic areas, like side
walks and roads or towards plants that may move in the
wind. This will cause the CatStop to activate frequently and
could wear down the battery. Alternatively, you can use the
CatStop with the Contech AC adapter.
Power Jack
•
Point the curved lens at the front of the unit toward the area
to be protected.
• I.R. viewing angle = 80 degrees horizontally, 10 degrees vertically.
• Detection range is up to 6m (20 feet).
• Area of protection is up to 25m
• Battery life = up to 500 activations
• Power supply = 9 volt battery (alkaline only) or Contech AC adaptor.
• Red LED for showing when the unit is activated.
• Speaker activates for 3 seconds.
• Fully water resistant
Includes two stakes for versatile mounting (ground level, approximately
10cm (4") above ground and approximately 23 cm (10") above ground).
Keyholes
How it works
6 m (20 ft.)
80°
Positioning the CatStop
Technical Specifications
2
(330 square feet).
2
Why it Works
1. Unlike many pest deterrents that operate continuously,
the CatStop unit waits for the animal to come into its
range before activating, thereby creating a more
startling effect.
2. Powerful burst of ultrasonic sound startles the cat.
3. The cat equates the location with the unpleasant
occurrence.
4. The cat avoids the location in the future.
5
Using Mounting Stakes
CatStop Unit
(View from Back)
1. Push the stake into the ground.
2. Attach the Cat Stop unit to the
Snap stake in here
mounting stake.
3. Use the extension stake if more
height is needed; snap together to lock.
4. Twist and pull apart stakes to unlock.
Cautions
For outdoor use only.
Do not hold the speaker to your ear.
Do not press against the lens.
Note: Some white cats, older cats and exotic breeds are by nature hard of
hearing in the upper hearing range and may not be affected.
Contech Electronics Inc.
Innovative technology for pets and gardens
6582 Bryn Rd
Victoria, BC, Canada V8X 1C3
www.contech-inc.com
Extension
Stake