Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11. When maintaining and repairing the lift table, wear
gloves and safety shoes. The safety stand bar should
be used to support the lift mechanism in order to
prevent table from falling. There should not be a
load on table while maintaining and repairing the
lift table.
ROUTINE CHECKLIST BEFORE STARTUP
— Check for any defect (especially on the wheels
or pump).
— Check if battery is fixed firmly and cable connected
properly.
— In case of any failure or fault, stop using the lift
table until it can be properly repaired.
STARTUP OF LIFT TABLE
— Rotate and turn off the emergency shutoff switch.
— Insert key into electric lock switch and turn right to
position "I".
— Battery capacity meter should indicate the current
capacity.
Figure 2
2
3
7
5
8
14
PAGE 2 OF 12
SAFETY GUIDELINES CONTINUED
OPERATION
PARTS LIST
1
15
11
12
10
6
13
9
4
12. The table is intended to be used for indoor
applications with ambient temperatures between
41° - 104° F (5° - 40°C).
13. This lift table is not water-resistant and should only be
used in dry conditions.
OPERATION OF THE LIFT TABLE
1
2
Figure 1
LIFTING OF THE LIFT TABLE
— Press the "RAISE" button to raise the table to
required height. (See Figure 1)
LOWERING OF THE LIFT TABLE
— Press the "LOWER" button to lower the table to
required height. (See Figure 1)
EMERGENCY SHUTOFF SWITCH
— All electric control functions are cut off when the
emergency shutoff switch is pressed. (See Figure 2)
1.
Loading Platform
2. Lift Mechanism
3. Hydraulic Cylinder
4. Swivel Caster
5. Rigid Caster
6. Motor Case
7.
Brake
8. Battery
9. Charger
1
RAISE Button
2
LOWER Button
10. Battery Capacity
Meter
11. Emergency Shutoff
Switch
12. Key Switch
13. Charging Indicator
14. Safety Stand Bar
15. Handle
0321 IH-3768
Publicité
Table des Matières
