Using The Appliance; Cleaning And Maintenance - Ghibli AS6 Utilisation Et Entretien

EN IT

USING THE APPLIANCE

N.B.
The appliance can only be used if the pa-
per bag is inserted correctly.
- The appliance is equipped with wheels
and during use can be dragged along us-
ing the hose.
- To lift it up, insert your fingers into the
handle (14 Fig. 8) on the top of the cover.
Switching on the appliance
- Insert the plug (15 Fig. 9) into the socket.
- Press the switch (16 Fig. 10), which lights
up, to switch the appliance on.
- When the light (17 Fig. 10) comes on, this
indicates that the paper bag is full and
must be replaced.
N.B.
The suction force can be adjusted using the
selector (18 Fig. 11) located on the ergonom-
ic handle (9 Fig. 11).
Opening up the window (19 Fig. 11) gives
lower suction power.
Using the telescopic tube
(if present)
- The length of the telescopic tube (20 Fig.
12) can be adjusted as follows:
- To lengthen the tube, press down on the
ring nut (21 Fig. 12) and simultaneously
extract the top part (22 Fig. 12) of the
tube. Once the required length has been
obtained, release the ring nut (21 Fig. 12)
the tube will lock into the nearest locking
position;
- To shorten the telescopic tube, use one
hand to push the ring nut (21 Fig. 12)
down and the other to reinsert the top
tube (22 Fig. 12) into the lower sleeve (23
Fig. 12).
Switching off the appliance
- Press the switch (16 Fig. 10) to switch off
the appliance.
- Remove the plug (15 Fig. 9) from the
socket.
- Wind up the cable (24 Fig. 13) and hook
it in position then couple the tube (9 Fig.
13) to the joint.
CLEANING AND
MAINTENANCE
DANGER:
Before performing any maintenance, un-
plug the appliance from the mains.
Removing and replacing the paper
dust bag
- Move the lever (1 Fig. 1) and remove the
cover (2 Fig. 1).
- Remove the suction hose by turning the
sleeve (6 Fig. 4) in an anti-clockwise di-
rection.
- Remove the paper dust bag (3 Fig. 2) and
replace it as described previously.
- Reassemble everything proceeding in re-
verse order compared to assembly.
Checking and cleaning the cartridge
filter
- The filter cartridge (25 Fig. 14) is pressed
into a special support. In order to remove
it, it must be lifted up.
- Clean the filter (25 Fig. 15) from the in-
side out with a blast of air. If there is too
much dirt, it must be replaced.
- Reassemble everything proceeding in re-
verse order compared to assembly.
Checking and cleaning the safety
filter
- Remove the filter cartridge (25 Fig. 14)
then remove the filter (26 Fig. 16) and
clean it with a blast of air.
The filter can be washed in warm water
and must only be replaced once it is com-
pletely dry. If it is too dirty, replace it.
EN - 2