Before using for the first time
• Run the coffee maker for the first time without coffee, rinsing the circuit with 1 litre of water.
Making coffee
(Follow illustrations 1-8)
• O pen the Filter holder support using the open button (g) located on the top of the coffee maker.
• U se cold water only and a No. 4 paper filter or the permanent filter. Do not use the insulated pot
without its top.
• D o not exceed the maximum amount of water indicated on the water tank level indicator.
• This coffee maker is equipped with a drip-stop feature so that you can serve a cup of coffee before all
the water has finished flowing through. Return the jug or the insulated pot to its base quickly to avoid
spillage.
• F or better heat preservation, rinse the insulated pot with hot water before use.
• T he lid of the isothermal coffee pot must be screwed on firmly in a clockwise direction until the
arrow on the handle is aligned with "unlock" to prepare and keep your coffee warm. To pour the
coffee, unscrew the lid by 1/2 turn until the arrow on the handle is aligned with "lock".
• W ait a few minutes before preparing another pot of coffee.
Flavour selector
(Follow illustration 9)
• T he flavour selector (h) allows you to adjust the intensity of the coffee prepared.
• T urn the selector (h) to the right to the position
amount of water contained in the tank passes through the coffee grounds.
• T o obtain a very weak coffee, position the selector (h) to the left to the position . Only about
half of the amount of water contained in the tank passes through the coffee grounds.
• The intermediate positions on the selector (h) allow you to adjust the intensity.
For the programmable model
Indication
Program-On indicator:
The
will display when you push on at "Auto-On" mode.
1-4 cups indicator:
icon will display when you push on the "1-4 cups" button but will not start the brewing.
The
ON indicator:
The
icon will display when you push ON the "On-Off" button (red light "R"). If the "1-4 cups" is
pressed, the
icon will be shown together.
Detail function key and operation method
Setting the time
• "H" and "min" buttons are used to set Time of Day;
• Default Time of Day is 0:00.
• T o set the hour, press the "H" button once, HOUR will increase from the initial 0:00 at one-hour intervals.
Pressing and Holding the "H" button for more than 2 seconds will make the HOUR advance at a
rate of about 3-5 hours per second.
To set minute, press the "min" button once, MINUTE will increase from the initial 0 at one-minute
intervals. Pressing and Holding the "min" button for more than 2 seconds will make the MINUTE
advance at a rate of about 3-5 minutes per second.
to obtain a normal coffee, where the entire
11
EN