Installation Instructions - INTERSTEEL DIGITAL DOOR VIEWER 2.2 Manuel De L'utilisateur

Installation instructions

1.Replace the existing door viewer or drill a 14mm hole in the door at the
required height. Peel off the 3M sticker top layer and then insert the camera
from the outside . Ensure the door bell button is under the camera and adjust
the camera vertically to the ground(FIG.1)
2.Peel off the 3M sticker top layer on the holding plate and fit the holding
plate over the end of the camera wires on to the back of the door. Make sure
the arrow on the holding plate points upwards. Then screw up the locking
barrel on to the back of the camera.This will hold the plate to the door(FIG.2)
3.When inserting the camera wire into the socket ,ensure you match the
connectors correctly.( If inserted the wrong way, this can damage the wires
on the camera) The excessive wire should be gently placed into the groove
at the back of the screen.
4. Hook the screen over the bracket at the top of the holding plate and secure
with one small screw through the hole at the bottom of the screen
case. (FIG.3)
:
FIG. 1
FIG. 2
FIG. 3
FIG. 4