Metalux WSL End Access Instructions D'installation page 2

Installation Instructions – WSL End Access
3. Secure Junction box lower half using screws provided.
(Figure 3.)
Figure 3.
4. Assemble Junction box upper half and Conduit fitting.
(Figure 4.)
JBox Upper Half
Figure 4.
5. Slide in Junction box upper half to channel. (Figure 5.)
Figure 5.
2
EATON
IB519026EN
Screws
Conduit Fitting
JBox
Upper Half
Installation instructions
6. Secure Junction box upper half using screws provided.
(Figure 6.)
Top Screw for Suspended Fixtures
Figure 6.
7 . Install cover and waveguide according to standard
fixture installation.
Figure 7.
8. Install Endcap to fixture. Tuck wire harnesses and safety
cable while installing. Endcap tabs must fully engage in
the metal bracket. (Figure 8.)
Endcap Tab
Sheet metal Bracket
in Waveguide
Figure 8.
Figure 9.
Screws
Endcap