Important - S&P ECOHAND Manuel D'instructions

DESCRIPTION OF THE APPLIANCE (FIGURE 1)
1. Information screen.
2. Upper hand sensor.
3. Lower hand sensor.
4. ON-OFF switch.
5. Air filter.
6. Water tank.
7. Water tank safety key.
8. Display light sensor.
9. Hand dryer indicator.
10. Hand location / movement indicator.
11. Drying time counter.
INSTALLATION
• Carefully read the safety warnings listed above before installing the appliance.
• (Figure 2) Ensure that the installation site respects the minimum clearances indicated. We
recommend you vary the height at which you install the appliance depending on whether it
is to be installed for use by men or women.
• Ensure that the wall where the appliance is to be installed is capable of withstanding the
weight of the appliance (13~14 Kg) plus a safety margin.
• Ensure that the space beneath the apparatus is kept clear, so that nothing can obstruct the
entry of air into the appliance.
• You can choose which side of the appliance you would like the power cable to exit, based
on the location of the power point to which it will be connected. Simply change the route
using the plastic cable fasteners.
• (Figure 3) Remove the two plastic caps located on either side of the appliance (A). Using a
screwdriver, remove both screws. Keep the screws and caps as you will need to replace
them once the appliance is attached to the wall.
• (Figure 3) Remove the metal walls support (E). Use the paper template provided to mark the
five points on the wall where you will need to drill holes in order to fix the support to the wall.
• (Figure 3) Drill five holes of 8mm in diameter and use the screws provided to fix the support
to the wall (E). Ensure that the screws are appropriate for the type of wall.
IMPORTANT: Before fixing the appliance to the wall, remove the three screws indi-
cated with the arrow (
• (Figure 3) Hang the appliance on the support (E) and secure it in place using the two side
screws removed earlier (A). Replace the two plastic caps to cover the screws.
• (Figure 1) Connect the appliance to an earthed power point. Press the ON/OFF switch (4)
and the appliance is ready for use.
Measurement Y
Men 900 mm
Women 850 mm
) from the back of the appliance.
8