elysia skulpter 500 Mode D'emploi page 5

Shape: Turn right to increase saturation/filtering effects.
Shape One is active per default; press corresponding button
for Shape Two. (p. 8)
LoCut: A variable low cut filter with a slope of 12 dB per
octave, ranging from 10 to 375 Hz. Turn right to raise the cut-
off frequency. (p. 9)
Comp: An intelligent soft knee compressor based on a
fixed 3:1 ratio. Fully left is off; turn right to lower the compres-
sion threshold. (p. 10)
Direct: High impedance/headroom direct input for instru-
ments etc. Note: The DI has priority over the mic input and will
automatically activate when a jack is connected.
Meter: A multi LED array showing input clipping (top),
output level or preamp gain (middle) and compression inten-
sity (bottom). (p. 11)
Shape Two: Changes the specially tweaked filter curve of
the sound shaper from instrument (LED off ) to vocal (LED on)
focused enhancement.
48V (Hold): Activates or deactivates +48V phantom pow-
er. Note: For safety reasons, the button must be pushed for a
period of two seconds to toggle its function.
Phase Reverse: Switches the phase from normal (LED off )
to reverse or vice versa. Note: This will automatically trigger a
signal mute for a few milliseconds to avoid cracking noises.
Signal Mute: Allows changing instruments and mics with-
out damaging ears and speakers, or a quick source signal
mute while playing back. LED is on while signal is muted.
(p. 8)
(p. 9)
5