Sylvania SP233 Mode D'emploi page 7

No sound:
Make sure volume is up.
Check that all connections are correct and properly plugged in.
Make sure your device is properly paired with the speaker.
Increase the volume on your device.
Sound is garbled:
Make sure the speaker is fully charged.
Turn down the volume on your device and the speaker.
Keep both devices within close distance.
Trouble pairing device with the speaker:
Confirm that your device is Bluetooth compatible.
Power cycle the speaker and your device, then try pairing again.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
---Consult the dealer or an experienced radio/TV technician for help.
1.This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure requirement. The device can be used
in portable exposure condition without RF striction
6