Uni-bond E-2230A Manuel D'installation

Wire Colour
Red
White
8-pin Connector
Permanent Mount with Adjustable Brackets
Pattern Selection
- This light has sequences of flashes per pattern
NO.
1 Left & Right Alternating Quad Flash (2 sequences)
2 Left & Right Alternating Quad Flash, Full Unit Quad Flash (3 sequences)
3 Full Unit Quad Flash (1 sequence)
4 Left & Right Alternating Single Flash (2 sequences)
5 Centre Quad Flash, Left & Right Quad Flash (2 sequences)
6 Left to Right Sequential Flash (6 sequences)
7 Right to Left Sequential Flash (6 sequences)
8 Centre Single Flash, Centre to Left & Right Sequential Flash (4 sequences)
Hardware List
Metal Support
Bracket
M7 - Rectangular
Spring Washers
Last Updated: 05/11/2022
Function
Power
Ground
Pattern Selection
(
8 Flash Patterns
Pattern
Tightening
Hook
x2 x2
M4 - Rectangular
Spring Washers
x2 x8
For more information, visit our website at: www.unibondlighting.com
INSTALLATION MANUAL
LED Warning Light Bars (E-2230A / E-2450A)
)
M7 - 70mm M4 - 8mm
Hex Bolt Hex Bolt
x2
Rubber Pads
Installation Instructions
1. Install support brackets to lamp using hardware provided
2. Install lamp on vehicle using tightening hooks
3. Run 12.8ft feed cable (8-pin Connector) from lamp to control box
x2
4. Install control box;
A) Attach 6" white wire to ground
B) Attach 6" red wire to battery feed
5. Use control box for flash pattern selection
Connect To
+12/24 VDC (Power)
- (Ground)
Control Box
M7 - Form A
Flat Washers
x8 x2
M4 - Form A
Flat Washers
x8