Storage; Disposal; Troubleshooting - HOLZMANN MASCHINEN KAM 535 Mode D'emploi

16.3 Storage

Improper storage can damage and destroy important machine parts. Store packed or
unpacked parts only under the intended ambient conditions!
When not in use, store the machine in a dry, frost-proof and lockable place to prevent the for-
mation of rust on the one hand and to ensure that unauthorised persons and in particular children
have no access to the machine on the other hand!

16.4 Disposal

Observe the national waste disposal regulations. Never dispose of the ma-
chine, machine components or equipment in residual waste. If necessary,
contact your local authorities for information on the disposal options availa-
ble.
If you buy a new machine or an equivalent device from your specialist retail-
er, he is obliged in certain countries to dispose of your old machine properly.
17

Troubleshooting

Handling the machine with the power supply up can lead to serious injuries or even
death. Always disconnect the machine from the power supply before servicing or
maintenance work and secure it against unintentional or unauthorised reconnection!
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains.
If you are unable to carry out necessary repairs properly and/or do not have the required train-
ing, always consult a specialist to solve the problem.
Trouble
Machine does not start
Glue is applied to rollers
Edge band is not glued
optimally
HOLZMANN MASCHINEN GmbH
NOTE
WARNING
Possible cause
 NOT AUS Schalter aktiviert
 Switch or a phase is broken
 Overheating protection activated
 too much glue added
 too little glue is added
www.holzmann-maschinen.at
TROUBLESHOOTING
Solution
 Turn the EMERGENCY STOP
switch to the right to unlock
 Repair the defective switch or
phase
 Let the heater cool down
 Decrease glue supply
 Increase glue supply
32
KAM535