Porter Cable PCC771 Manuel D'instructions page 3

This Class B digital apparatus complies with Canadian ICES-003.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTICE: Per FCC Part 15, changes or modifications to this equipment not expressly
approved by PORTER-CABLE could void your authority to operate this equipment.
WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to
rain or moisture. Use only in dry locations. USE ONLY WITH PORTER CABLE BATTERY
PACKS. OTHERS MAY BURST CAUSING PERSONAL INJURY AND DAMAGE.
WHEN USING THE AC RECEPTACLE, FULLY INSERT ATTACHMENT PLUGS. DO NOT
USE THE RECEPTACLE IF THE ATTACHMENT PLUG CANNOT BE FULLY INSERTED.
WARNING: DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
• This product contains a coin/button cell battery. If the coin button cell battery is swallowed,
it can cause severe internal burns in just 2 hours and can lead to death.
• Keep new and used batteries away from children. If the battery compartment does not
close securely, stop using the product and keep it away from children.
• If you think batteries might have been swallowed or placed inside any part of the body,
seek immediate medical attention.
WARNING: To prevent electric shock, match wide blade of plug to wide slot fully insert.
• Do not disassemble radio. Take it to an authorized service center when service
or repair is required. Incorrect reassembly may result in a risk of electric shock,
electrocution or fire.
• Disconnect the radio from the outlet before attempting any cleaning. This will
reduce the risk of electric shock. Removing the battery pack will not reduce this risk.
• This radio is designed to operate on 120 Volts, 60 Hz AC. It also operates on Porter-
Cable battery packs. Do not use any other voltage. Only use adapter provided.
The label on your tool may include the following symbols. The symbols and their definitions
are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ...direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
...............shock hazard symbol
A ...................amperes
W ..................watts
or AC .......alternating current
n o .................no load speed
.................earthing terminal
................safety alert symbol
.../min or rpm...revolutions or
reciprocation per minute
NBC ............ no battery connection
3