What To Do If - Everglades EVTT1019 Mode D'emploi

What to do if...

Warning! Before troubleshooting,
disconnect the power supply. Only a
qualified electrician or other
personnel must carry out the
troubleshooting that is not in the manual.
Important!
Repairs to the appliance may only be
Problem
Appliance dose not
work.
Appliance cools too
much.
The food is too warm.
Interior lighting dose
not work.
Heavy build-up of
frost, possibly also on
the door seal.
Unusual noises.
The compressor dose
not start immediately
after changing the
temperature setting.
Water on the floor or
storage shelves.
possible cause
Appliance is not switched on.
Main plug is not plugged in or is
loose.
Fuse has blown or is defective.
Outlet is defective.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an extented
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air-tight
(possibly after reversing the
door) .
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
This is normal, no error has
occurred.
Water drain hole is blocked.
performed by competent service engineers.
Improper repairs can give rise to significant
hazards for the user. If your appliance
needs repairing, please contact your
specialist dealer or your local Customer
Service Center.
Solution
Switch on the appliance.
Plug the appliance into the
electrical socket.
Check fuse, replace if necessary.
Defective parts need to be
repaired by an electrician.
Turn the temperature regulator to
a warmer setting temporarily.
Please refer to the "Starting up and
temperature regulation" section.
Open the door only as long as
necessary.
Turn the temperature regulator to
a warmer setting temporarily.
Please refer to the "Installation
positioning" section.
Please look in the "Changing the
Light Bulb" section.
Carefully warm the leaking
sections of the door seal with a
hair dryer (on a cool setting). At
the same time, shape the
warmed door seal by hand so
that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
The compressor starts after a
period of time.
Refer the "Cleaning and Care"
section.
14