Initial Operation; Hose Connection; Electrical Connection - Exit MSP-30107-V01 Mode D'emploi

may reduce the running efficiency and possibly prevent sufficient heat output.

4.2 Initial operation

Note: In order to heat your pool water, the water pump must run firstly to make the
water circulated through the heat pump. Your heat pump will not start up if the water
is not circulating.

4.3 Hose connection

Note:
The upper connection port at heat pump's right side is for water outlet, and the lower
port is for water inlet.

4.4 Electrical connection

Before connecting the heat pump, make sure that the supply voltage matches the
operating heat pump's voltage. There's RCD plug that equipped with power cable, it
help to offer a full electrical protection.
When all connections have been completed and checked, carry out the following
procedure:
1). Switch on the water pump. Check for leakage and verify that water is flowing
incoming and outgoing to the swimming pool.
8
MSP-30107-V01