Teka CI 345.1 Mode D'emploi page 9

FULLY BUILT IN REFRIGERATION
FITTING INSTRUCTIONS
MODELS FOR UNDER-COUNTER FITTING
REVERSING THE OPENING OF THE DOORS
This appliance is designed so that the opening of the doors can be reversed. To achieve
this proceed as follows:
SINGLE DOOR
REVERSING THE DOOR (fig. 1)
- Remove hinge pin 1 and hinge bush from top rail.
- Remove the door.
- Remove journal 3 (and the relative washers) from the lower right-hand hinge and refit it
to the lower left-hand hinge.
REVERSING THE LOW TEMPERATURE COMPARTMENT DOOR (fig. 4)
In models with freezer compartments, in order to reverse the door, proceed as follows:
(fig.4a):
- Open door 1 to about 90°.
- Remove coupling 2.
- Remove hinge 3 together with door 1.
- Turn the three items 180° and refit everything by reversing the procedure.
(fig.4b):
- Open the door to 90 degrees.
- Remove the bracket 2.
- Remove the lower hinge 3.
- Turn the door (1) round by 180 degrees and fix the bracket (2) on to the opposite
side.
Two door refrigerator (fig. 2):
- Remove upper hinge 1 and journal 2 (and the relative washers).
- Remove the upper door.
- Remove central hinge 3 (and the relative washers).
- Remove the lower door.
- Remove journal 4 (and the relative washers) from the lower right-hinge and refit to the
lower left-hand hinge.
- Reverse screws 7, screw cover plugs 6 and hole cover plugs 5 on the unit.
- Furthermore, with models fitted with side fixing clamps, instead of the hole cover plugs
5, reverse the clamp covers (fig. 3) which are fly-fitted on the clamp.
Combi (fig. 3):
- Remove hinge pin 1 and hinge bush from top rail.
- Remove the upper door.
- Remove the centre hinge 2 (and the relative washers).
- Remove the lower door.
- Remove journal 3 (and the relative washers) form the lower right-hand hinge and refit it
to the lower left-hand hinge.
- Reverse the fly-fitted clamp cover 4, mounted on the clamp.
9