Cleaning And Care - Waldbeck Lakeside Powerplus Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

EN
16
All manuals and user guides at all-guides.com
Using the device for wet and dry vacuuming
Fit the blanking plug (5) at the outlet of the collecting vessel.
For wet vacuuming: Fasten the filter sponge for the motor (13) (see pond
and pool vacuuming device).
For dry vacuuming: Fasten the paper filter bag (15) to the inside of the
upper opening of the collecting vessel.
For switching on the device, turn the switch (2) to I, MANUAL. In this
position, the device operates continuously in continuous operation
without interval switching.
Check the filling level of the collecting vessel from time to time and, if
necessary, empty or replace it.
Switch off the device after use (0), pull out the net plug and clean collecting
vessel as well as filter inserts.
Switching/Operating Modes
Switch position 0
Motor off
Switch position I
Manual operation (ON/OFF) for wet/dry vacuuming operation
Switch position II
Automatic operation for pond and pool cleaning
After switching on, the motor will suck for 30 seconds.
b) Motor stops after approximately 30 seconds to drain.
Auto Start after 30 seconds.
Repetition (a) and (b) to OFF (0).

CLEANING AND CARE

Thoroughly clean the collecting vessel and dirt collecting bag (4) with
water and, possibly, with a little mild household cleaner.
Check suction hose (9), suction tubes and drain hose (3) occasionally for
possible blocking or dirt residues and remove them.
Carefully wash the filter sponge for the motor (13) with water and.
possibly, with a mild household cleaner and dry it afterwards.

Publicité

Table des Matières
loading

Produits Connexes pour Waldbeck Lakeside Powerplus

Ce manuel est également adapté pour:

1003342310033424

Table des Matières