Cleaning and maintenance
The pump is nearly maintenance-free.
If you are using the pump as a permanent installation, you should check the function of the
floating switch every three months. Remove any deposits from the float and wash any mud,
etc. off the pump's impeller.
Troubleshooting
The motor does not start
The pump is operating but
does not deliver
Insufficient flow rate
Guarantee and service
Our products undergo a strict quality-control process before delivery. If the product has
unexpectedly been damaged or developed a defect during production or transport, please
return it to the retailer. You can legally make a claim under the guarantee in the following
circumstances :
The product is covered by a 2-years guarantee from the date of purchase. During this period,
we will repair or replace the product if it is found to be defective due to material or production
faults.
Faults caused by incorrect use or handling, faults caused by unauthorized intervention or
repairs, and faults caused by use of non-original parts are not covered by the guarantee.
•
There is no power
•
Temperature monitor
has switched off
because the impeller is
blocked
•
Air in the pump
•
Suction base clogged
•
Maximum discharge
height exceeded
•
Strainer dirty
•
Decreased pump
performance
www.chestergarden.be
•
Check the connections
and voltage
•
Allow the pump to
cool, dismantle it and
clean it
•
Turn the intake
opening of the pump
under water and allow
the air to escape
•
Clean the suction base
•
Check the discharge
height
•
Clean the strainer
•
Clean the pump,
remove debris
GB
14