Before Use; Initial Operation - Wurth Master ISS 45-M automatic Notice D'utilisation

ISS 45.book Seite 12 Montag, 12. Februar 2007 10:39 10

Before Use

Check for correct mains voltage: The voltage of the
power source must match the voltage specified on the
nameplate of the machine.
Assembly (figures 1 - 6)
– Unlock and remove the suction head.
– Take out accessory parts, wheels and casters.
– Mount wheels/casters as shown.
– Insert and lock the vacuum hose.
– Mount hand piece/extension wand (s).
Fitting/replacing the paper filter bag
(figure A/figure I)
The machine is equipped with a paper filter bag
with closing slider.
If the paper filter bag is full and the volume flow
falls below the minimum level, the bag must be
changed.
At the end of its service life, the machine is to be
disposed of according to statutory regulations.
– Insert the connector for the vacuum hose into the vac-
uum hose connection.
– Slide in the connector for the vacuum hose to the
stop.
– Firmly tighten the vacuum connection with the con-
nector for the vacuum hose by turning it in clockwise
direction. The "bayonet connector" ensures an accu-
rate fit (Figure I).
– Pull out the paper filter bag toward the rear (1). Pull
the closing slider (2) upward and tightly seal the pa-
per filter bag when pulling it out (Figure I - see im-
print on the packaging of the filter element).
– Dispose of the used filter element in a dust-tight,
sealed bag according to statutory regulations.
– Inserting a new paper filter bag (Figure A)
– Replace the suction head and lock it in place.
12
All manuals and user guides at all-guides.com
Switching On and Off (Figure B)
– Switching the machine on and off:
– Remote automatic starting switch 4:
– Filter-cleaning switch 2:
Automatic mode (External Dust Extraction
on Power Tool)
– Adapt the connection sleeve to the electric tool's ter-
– Remove hand piece from vacuum hose and mount
– Connect the connection sleeve to the electric tool
– Plug the electric tool's power plug into the vacuum
– Switch the vacuum cleaner on and push the On/Off
Automatic Filter Cleaning (figure G)
Your vacuum cleaner is provided with a new type of fil-
ter cleaner – especially effective for fine dust.
To ensure that the air speed during the vacuuming pro-
cedure never falls to below 20 m/s in the vacuum hose,
the machine is additionally equipped with a differential
pressure indicator.
– The LED (filter cleaning ON) on switch 2 is lit.
The flat-folded filter is cleaned automatically every
15 seconds by means of an air blast (pulsating noise).
Adjusting the Vacuuming Capacity
(figure C)
Adjust the vacuuming capacity with regulator 6.

Initial Operation

Insert the power plug and push On/Off switch 1.
Upper position: OFF
Bottom position: ON
LED not lit : OFF
LED lit : ON
minal connection (figure D).
vacuum hose adapter (figure E).
(figure F).
cleaner (figure C).
switch of the power tool. The remote automatic start-
ing switch 4 must be in the bottom position (automat-
ic ON).
The vacuum cleaner is automatically switched
on and off with the electric tool.