Felker TILE MASTER TM-1HT Instructions D'utilisation page 18

14 TILE CUTTING ACCESSORIES
ANGLE GUIDE
Parts List:
Diag. Part No. Qty.
1 050104 1
2 050107 1
3 050105 1
4 050106 1
5 050103 1
6 189737 2
7 051020 1
8 189737 1
9 N/A 1
RIP GUIDE: P/N 051000 - The Rip Guide is a standard ac-
cessory supplied with every tile saw. It is used to
provide a repeatable position for rip cuts until relocated.
The Rip Guide clamps to the machined backstop of the
conveyor cart.
ADJUSTABLE PROTRACTOR:
Protractor can be used to rip cut known angles. The
protractor clamps to the backstop.
ANGLE GUIDE : P/N 051020 - This is a non-adjustable mi-
ter used to quickly position the tile at 45 degrees; either
on the left or right side. It is often used for repeated
diagonal rip cuts. The Angle Guide clamps to the back-
stop.
The instructions for use and spare parts found in this document are for information only and are not binding. As part of
our product quality improvement policy, we reserve the right to make any and all technical modifications without prior
18
PROTRACTOR MITY MITRE GUIDE
Description
Frame, Miter
Bar, Locking
Clip, Stop
Spring
Knob, 1/4"-20 x 1"
Screw, Thumb, 1/4"-20 x 1"
°
Miter Assy, 45
Knob, 1/4"-20 x 1"
Sector Plate
P/N 051010 - The
The manufacturer accepts no
responsibility caused by unsuitable
Diag. Part No.
10 N/A-
11 020011
12 020244
13 189737
14 051010
15 020598
16 051030
17 051041
18 050102
BULLNOSE MITRE GUIDE: P/N 051030 -This is a fixed
guide that positions the tile for a 45 degree miter cut.
The Mitering Guide clamps to the backstop.
PRECISIN MITERING JIG: P/N 161480- This is a 45 degree
fixture that has an adjustable clamp to hold the tile while
miter cutting. The Mitering Guide clamps to the back-
stop.
FOLDING STAND: P/N 051041 - This stable, one piece stand
brings a FELKER® tile saw to standing level for ease of
work. The stand conveniently folds flat for storage and
transporting.
notice.
use or modifications.
BULLNOSE FOLDING STAND
Qty. Description
1 Arm, Protractor
1 Carriage Bolt, 1/4-20 x 5/8"
1 Wing Nut, 1/4-20
1 Knob, 1/4-20 x 1"
1 Protractor Assy
1 Screw, Thumb, 1/4"-20 x 1"
1 Holder Assy, Bullnose
1 Stand, Tile Saw (for TA Models only)
1 Support Assy, Miter Frame