Installation; Preparing For Installation - Glacier bay 67070-3301 Guide D'utilisation Et D'entretien

Installation

1

Preparing for installation

CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply.
□
Before installation, remove the quick connector (I)
from the free end of the hose by unscrewing it in a
counterclockwise direction.
□
Unscrew the nut (D), and remove the
washers (B & C).
NOTE: If installing the faucet assembly (A) without the
escutcheon, begin with step 2. If installing the faucet
assembly (A) with the escutcheon, begin with step 3.
C
D
All manuals and user guides at all-guides.com
A
B
I
2
Installing the faucet assembly
NOTE: This step is for no escutcheon installation (optional).
If the escutcheon will be used, install the faucet assembly
as described in step 3.
□ Retract the hose (1) up through the faucet body
until the hose tting is ush with the bottom of
shank (2). Do not pull the hose tting past the
shank. Insert the faucet body through the hole
in the sink.
NOTE: Do not feed the hose (1) back down through the
spout until step 6.
5
Please contact 1-855-HD-GLACIER for further assistance.
A
2
1
HOMEDEPOT.COM