Sunbeam Aer1 Total Manuel D'instructions page 5

C L E A N I N G / M A I N T E N A N C E
CLEANING/MAINTENANCE
INSTRUCTIONS
1. Turn the air purifier off and unplug it before
cleaning.
2. The outside of the air purifier can be cleaned with a
soft, clean dampened cloth.
3. The air inlet grill (reference Figure 1) can be
removed and washed in warm soapy water (not
dishwasher safe). Dry before replacing in the unit.
4. The filtered air outlet can be cleaned of dust with a
small, soft brush.
5. If you wish to clean the inside of the air purifier,
please only use a dry, soft cloth to wipe it down. DO
NOT WASH the Aer1
washed by using a mild dish soap and water. Rinse
thoroughly. Allow to air dry completely prior to
reinstalling into the Air Inlet Grill (I).
6. NEVER use detergents, gasoline, glass cleaner,
furniture polish, paint thinner or other household
solvents to clean any part of the air cleaner.
WARNING: Do not allow moisture to come in
contact with the main housing of the air purifier.
FILTER REPLACEMENT INSTRUCTIONS
NOTE:
Every few weeks, check the condition of filter. Filter life
will vary, depending on air quality and usage (see
below). Under normal conditions of continuous use, the
Aer1 Total Air and Odor Filter will last 4 months while
TM
the Allergen and Germ Filter will last 12 months.
After approximately 4 months of operation, the Filter
Check Indicator Light will illuminate to alert you to service
the filter:
• Filters with a 4-month filter life: This Filter Check
indicator is to remind you to perform maintenance to
wipe your unit clean, wash the foam pre-filter and to
replace the Aer1™ filter.
• Filters with a 12 month filter life: This filter Check
indicator is to remind you to perform annual
maintenance to wipe your unit clean, wash the foam
pre-filter and to replace the Aer1™ filter.
F I LT E R R E P L A C E M E N T
filter. The Pre-filter (H) can be
TM
To replace your filter:
1. Turn off and unplug the air purifier.
2. Open the air inlet grill and examine the black foam
prefilter. Remove any dust or lint, and wash in warm
soapy water. Rinse, drip dry, and place back into grill
inlet.
3. Remove the Aer1 filter from the unit by pulling it
TM
gently towards you and discard it. DO NOT attempt to
clean the old Aer1
TM
4. Install the new Aer1
TM
utilizes a hang tab and filter clips to insure that the
filter is properly in place. Before replacing the filter,
make sure that the hang tab is securely in place. The
clip can only be attached to the tabs on the filter one
way. The filter clip
should easily slide onto
the filter hang tab with
only a small amount of
pressure. DO NOT use
force while attaching
the clip to the filter.
(Fig. 2)
5. Align the clip on the
side of the filter with
rails on the inside of
the purifier unit.
Gently slide the filter
onto the rail. (Fig. 3)
6. Replace air inlet grill.
7. To reset the Filter
Check Indicator, press and hold the Filter Reset Button
for 3 seconds. The Indicator light will blink three
times and turn off.
filter.
filter into the unit.This model
Fig. 2
Fig. 3