Uline S-21803 Mode D'emploi page 2

5. Examine the installation from the exterior.
Air bubbles, water pockets or dirt are more visible
from outside than inside.
1. Use a piece of office tape to assist when removing
the liner. Place a small piece of tape on either side
of one corner and pull in opposite directions
2. If film solution freezes on window, do not apply film.
3. Film cannot be applied effectively to rough, frosted
window glass or a window that has a painted sign or
picture on the inside.
4. Window film is not recommended for Plexiglas
polycarbonate.
PAGE 2 OF 6
TRIMMING/CLEANING CONTINUED
TIPS
or
®
1-800-295-5510
uline.com
NOTE: If some moisture remains after using the
squeegee, reapply a light mist of film solution
and squeegee. Slight moisture buildup may
occur and will dry within several days. Allow
additional drying time in colder climates.
5. 10-15% of the moisture stays between the glass and
the film immediately following installation. Some
cloudiness may occur during curing stage, but will
disappear over time.
6. Adhesive and film solution can be squeegeed for 10
to 60 minutes before the film locks down.
7. To clean window film, use any commercial products
that do not contain ammonia.
0621 IS-21803