Getting Started; Volume Control - Sonik Gizmo Mode D'emploi

GETTING STARTED

Battery Fitting/Replacement
Remove the battery compartment cover by sliding it carefully down to remove it from
the casing. Insert 2 x AAA 1.5V batteries noting the polarity shown on the connection
terminals. Alarm speaker will sound when batteries are fitted correctly. Replace the
battery cover ensuring that it closes positively into place.
SWITCHING ON / OFF
To turn the alarm on, press and hold the on/off button; LED's will flash four times.
To turn the alarm off, press and hold the on/off button; LED's will flash once.

VOLUME CONTROL

To adjust volume, turn the V-dial. The first volume setting is silent.
TONE CONTROL
To adjust tone, turn the T-dial. The speaker will sound the tone selected.
SENSITIVITY CONTROL
To adjust sensitivity, turn the S-dial.
INTELLIGENT MUTE MODE
Press the on/off-button to enter mute mode. Illuminated snag ears will alternate flash
for 30 seconds then the alarm will automatically re-arm. Pressing the on/off-button
at any time during the 30 seconds will exit mute mode.
EXTENSION OUT SOCKET
Located on the underside of the alarm this is compatible with most illuminated indica-
tors with 2.5mm jack plug connection.
G-ALARM-ENG.indd 4 G-ALARM-ENG.indd 4 19/05/2020 12:18 19/05/2020 12:18