Armacost Lighting RigidStrip Guide Rapide

RigidStrip
(1) 12-in. RigidStrip Linkable LED Light
(2) Mounting bracket
clips with screws
and adhesive pads
(1) Removable clear end cap
Connections and installation
Measure your intended installation space and round down to the nearest
whole foot to determine the number of RigidStrips you need. Only 8
RigidStrips can be connected in a single leg, but the number of legs
you have is limited only by the wattage of your power supply.
POWER
SUPPLY
Use only with low-voltage DC constant voltage power supplies. Never
connect RigidStrip linkable lights directly to 120-volt household power.
Use the chart below to determine wattage consumption for each leg.
Add this fi gure for all lighting legs to determine total system wattage.
Approximate watts used at full brightness
12-Volt RigidStrip
1 2 3
Pieces
Watts used 3.5 6.7 10
24-Volt RigidStrip
1 2 3
Pieces
Watts used 3.5 6.9 10.1
Do not exceed 8 RigidStrips in one leg.
Before installation of your RigidStrip Linkable LED Light, consider your
placement options. See sidebar.
Plan out your RigidStrip installation by marking a straight line on your
mounting surface. Mark at 6-inch intervals for the surface mount clips.
Install the clips using the double-sided adhesive or the included screws.
Mount clips 6 inches on center
™
Linkable LED Light
12-volt or 24-volt LED power supply
(to match the voltage of the RigidStrip model –
sold separately)
RigidStrip Power
Lead Connector,
at least one for up to
8 lights
(sold separately –
item number 396810)
8 pieces max
LEG 2
8 pieces max
LEG 3
8 pieces max
4 5 6 7
12.6 15.5 18 20
4 5 6 7
13.4 16.2 19 21.8
REQUIRED USE
Placement options for RigidStrip Linkable Lights
For maximum light output,
mount the light towards the
front of the cabinet with LEDs
facing down. To focus light on
the work surface and also light
your backsplash, position the
LEG 1
RigidStrip an inch or two back
from the front of the cabinet.
The refi ned fi xture appearance
make RigidStrips perfect for fl at-
bottomed shelves or cabinets.
8
If your mounting surface has
a front lip, consider installing
22
the RigidStrip Light on the inside
back of the lip with the LEDs
facing towards your backsplash.
8
This method provides a different
24.5
illumination effect.
Light length: 300mm
– 12 inch
Overall length: 310mm
OPTIONAL USE
RigidStrip Jumper Connector, for turns
or gaps in your circuit
LED dimmer or AC dimmable power supply
RigidStrip installed
through a slot sawed
into cabinet divider.