Operating instructions
Mini HDMI extension via patch cable
Item no. 1693320
Intended Use
The product is intended to extend the limited transfer length of HDMI cables via a
separately available network cable to up to 50 meters. Power is supplied via USB.
This product is intended for indoor use only. Do not use it outdoors. Contact with
moisture (e.g. in bathrooms) must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product.
Using the product for purposes other than those described above may damage the
product. In addition, improper use can cause hazards such as a short circuit, fire or
electric shock. Read the instructions carefully and store them in a safe place. Only
make this product available to third parties together with its operating instructions.
This product complies with statutory, national and European regulations. All company
and product names are trademarks of their respective owners. All rights reserved.
HDMI is a registered trademark of HDMI Licensing L.L.C.
Delivery Content
• Transmitter
• Receiver
• 2 x USB cable
• Operating instructions
Up-to-date operating instructions
Download the latest operating instructions at www.conrad.com/downloads or scan
the QR code shown. Follow the instructions on the website.
Explanation of symbols
The symbol with the lightning in a triangle indicates that there is a risk to
your health, e.g. due to an electric shock.
The symbol with an exclamation mark in a triangle is used to highlight
important information in these operating instructions. Always read this
information carefully.
The arrow symbol indicates special information and advice on how to use
the product.
Safety instructions
Read the operating instructions and safety information carefully. If
you do not follow the safety information and information on proper
handling in these operating instructions, we will assume no liability
for any resulting personal injury or damage to property. Such cases
will invalidate the warranty/guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. It may become
a dangerous toy for children.
• Protect the product from extreme temperatures, direct sunlight, strong
jolts, high humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of
operation and protect it from any accidental use. Safe operation can no
longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a
low height may damage the product.
• Always observe the safety information and operating instructions of any
other devices which are connected to the product.
• Do not disconnect the plugs during transmission. Stop playback and
switch off the connected devices before you disconnect the plugs.
• Consult a technician if you are not sure how to use or connect the
product, or if you have concerns about safety.
• Maintenance, modifications and repairs must be done by a technician or
a specialist repair centre.
• If you have questions which remain unanswered by these operating
instructions, contact our technical support service or other technical
personnel.
Product overview
Transmitter
1
2
1 RJ45 jack
2 HDMI plug
3 Micro USB socket
Receiver
4
5
4 RJ45 jack
5 HDMI plug
6 LENGTH button
7 Micro USB socket
Connection
a) General Information
• First switch off all devices to be connected.
• Use a CAT6/6A/7 network cable with a length of up to 50 m.
• The network cable should be at least 15 m long. Using a shorter cable may, under
certain conditions, result in an excessively strong output signal so that no image
is displayed.
• If you also use an HDMI extension cable, its length may not exceed 5 m.
• Note the imprint on the top side to differentiate the receiver (labelled: Receiver)
and the transmitter (labelled: Sender). Another distinguishing feature is the
LENGTH button which is only on the receiver.
3
6 7