ALPATEC PR3M 1000 Mode D'emploi page 7

All manuals and user guides at all-guides.com
notice PR3M/RMW 4/04/07
On the floor :
• Fix the two caster frames (6) at each side
of the heater as shown in the following diagram.
• Chek the caster frames installation before using.
On the wall :
• Mark first screw hole on the wall (about one meter
from floor).
• Drill first hole, then insert first screw anchor (12) into the first hole with a hammer.
• Put mounting support (10) on the wall and tighten lightly the first screw (11).
• Mark second screw hole on the wall by raising the support in
parallel to the floor. (at about 158 mm)
• Drill second screw into the second hole and then insert the screw anchor (12).
• Tighten both screws.
• Fix the feet cover (13)
• Place the mounting holes of the support (9) at level of screws. Then the appliance is fixed.
• Insert the plug into the socket. The red indicator (4) lights up.
• Turn the power switch (1) to « I » position, then adjust the thermostat (3) until its red indicator (1) lights
up.
• The red lighting indicator (1) will turn off as the room reaches the desired temperature which has been
set on the thermostat (3).
• If the room temperature falls, the heater will turn on again and release heat until the room temperature
rises to the desired temperature.
• According to personal needs, temperature can be increased or decreased with the thermostat.
• Anti-frost function keep the surrounding temperature above « Freezing Point ». To do this turn the
thermostat until the « snowflake » mark.
• ECO Green position: when the heater is switched on, the ECO Green indicator (2) is off. If the MICA
element reaches 60°C then the appliance switches into ECO function, ECO Green indicator is on, one
third of the power is cut off for energy saving and the heater gives back the accumulated heat. If the
MICA element temperature comes down to 54°C, the heater switches back to full power.
Models
Full power
Power while ECO position
• In case of overheat, a safety device know as « Thermal cut-off » has been installed within the heater.
• Before any cleaning or maintenance operation, switch off and unplug the appliance.
Ensure it is perfectly cooled.
• To remove the dust, wipe your appliance with a cloth.
• Never use abrasives or detergents.
15:00 Page 7
INST ALLA TION
INST ALLA TION
OPERA TING INSTRUCTIONS
OPERA TING INSTRUCTIONS
PR3M 1000 PR3M 1500
RMW 1000 RMW 1500
1000 W 1500 W
660 W 1000 W
MAINTENANCE
MAINTENANCE
7
PR3M 2000
RMW 2000
2000 W
1330 W