Velleman Velbus VMB4IRT Guide Rapide page 4

How to setup your remote control
In order to be able to use the VMB4IRT remote control with your device, the remote and/or your device must be configured in the correct way.
First, remove the 3 screws at the back of the remote and open the unit. Next, select your device from the list below and follow the appropriate setup procedure.
Note: The devices listed below are supported at time of printing. Please check www.velleman.be for an up to date list, as devices might have been added.
1. For use with the VMB4PD
• Press and hold the 'Mode'-button of the remote
• Press and hold button '3'of the remote. The indicatorled of the remote will flash briefly every 3s.
• Watch the VMB4PD closely.
• As soon as button 1 of the page you wish to control is activated, release all buttons of the remote.
• The 3 remaining buttons of the page are controlled with button 2, 3 and 4 of the remote.
• This procedure can take a couple of minutes, depending on the address setting of the VMB4PD
• Close the remote by means of the 3 screws
• You device is ready to be used
- 4 -