Hardware Installation - D-Link DNR-2020-04P Guide De Démarrage

Back Panel - DNR-2020-04P
C F
A B D E G
Figure 2. DNR-2020-04P Back Panel
Item Feature
Power Connect the supplied power cord
A
Input to the input port.
Connect a camera using a CAT5
Ethernet cable to each 10/100 PoE
port. A solid green light indicates
PoE Ports that LAN is connected. This light
B
1-4 will blink during data transfer. If
the light is solid orange, power via
PoE is normal. If orange LED is off,
there is no power.
Connect a microphone to the
Audio In port to use 2-way
c o m m u n i c a t i o n w i t h y o u r
Audio In / camera(s). Connect external
C
Out speakers to the Audio Out port
for live audio or audio playback.
Please note that your camera(s)
must support this feature.
Gigabit
Connect the device to your router
D Ethernet
or switch using an Ethernet cable.
Port
HDMI Connect to your TV or monitor
E
Output
using an HDMI cable.
VGA Connect a monitor using a D-sub
F
Output cable.
Connect a flash drive or a USB
hard disk with external power
for video backup, export video,
USB 3.0 or firmware upgrade. Optionally,
G
Port connect a mouse/keyboard to
control the management UI when
a monitor is connected via HDMI
or VGA.
Connect four DI trigger devices
H DI/DO
and one DO device to these ports.
Grounding Connect a grounding wire to
I
Port ground the NVR.
Press and hold the reset button
Reset
J for 10 seconds to reset to factory
Button
default settings.
Table 2. Back Panel Descriptions
2  D-Link JustConnect 16-Channel PoE Network Video Recorder
All manuals and user guides at all-guides.com
H I
J
Description

Hardware Installation

Hard Drive Installation
1. Access the DNR-2020-04P's
drive (HDD) bays by removing the screws
from the sides and back of the device.
2. Once the cover
rearward to remove it from the device.
3. Detach the HDD bay bracket, then insert
one or two 3.5" SATA hard drives into
the drive bays and
screws to secure the drives in the bracket.
4. Connect the power and SATA cables from
the device to each HDD. If a drive has been
inserted correctly, the HDD LED will light up.
5. Re-attach the drive bay bracket to the device
enclosure by sliding the tabs into the holes and
using the screws provided to secure it.
hard disk
is removed, slide
use the provided
it