Appliance Description; Operation And Use; Operating Panel; Safety Equipment - Beem Air Joy Cool Mode D'emploi

BEEM - Elements of Lifestyle
NOTE
► When using for the first time, it is
possible that production-related additives
such as grease could cause slight odour or
smoke. This is completely normal. Ensure
sufficient ventilation.

Appliance description

Overview / Delivery contents
(See illustration on the left fold-out page)
1 Air ring
2 Air slot
3 Maine ON/OFF switch
4 Foot with inclination adjustment
5 Remote control (without batteries)
6 Operating panel with blue indicator light
7 Wall mounting (not illustrated)
8 User manual (not illustrated)

Operating panel

Symbol Function
Switching the appliance ON/
OFF
Setting the continuous
air flow.
Switch rotation
movement ON/OFF

Safety equipment

A safety switch is located on the underside
of the pedestal. The appliance then switches
itself off automatically if it is tipped or falls
over.
1. For this reason, always place the appli-
ance on a firm and even surface so that the
safety switch is in contact with the surface.
2. Switch on the device.
To check the function of the safety switch,
proceed as follows:
1. Lift the pedestal of the appliance slightly
so that there is no contact to the surface. The
safety equipment switches off the appliance.
All manuals and user guides at all-guides.com
2. Put the appliance back onto a firm, flat
surface and switch it on manually.
NOTE
►
the appliance, it does not NOT switch on
again automatically. It must be switched on
manually.
To switch off the appliance, proceed as follows:
1. Move the main ON/OFF switch on the
pedestal to the "I" position.
2. Press the
panel. The blue indicator lamp lights up.
3. To switch off the appliance, press the
button again. The blue indicator lamp extin-
guishes.
4. Move the main ON/OFF switch (4) on the
pedestal to the „0" position.
Continuous setting of the air flow takes place
via the regulator
panel (6).
1. Turn the regulator clockwise to set a
stronger air flow.
2. Turn the regulator anticlockwise to set a
weaker air flow.
Switching the rotating movement on and off
takes place via the
ing panel (6).
The direction of the airflow is set via the incli-
nation adjustment on the foot (3).
►
movement is switched off.
►
mum in order to avoid damaging the unit.
1. Hold the foot tight with one hand.
2. Change the inclination of the appliance
with the other hand until the desired airflow
angle has been set.
If the safety equipment switched off

Operation and use

Switching the appliance on/off
button on the operating
Setting the air flow
button on the operating
Rotating movement ON/OFF switch
Directing the air flow
NOTE
Only direct the airflow when the rotating
Carefully tilt the unit up to stop maxi-
EN 11
button on the operat-