Mode Function - Koenic KTF 121 Mode D'emploi

English
Changing Battery
Open the battery compartment. Insert
1
1 x battery (not included) of type CR2025
observing the + and – polarities as indicated
on the battery and inside the battery
compartment.
Assembly and installation
Remove the screws from the lower end.
2
Attach rear part of foot, matching the screw
holes. Insert and fasten the screws.
Attach front part of foot, matching the
3
screw holes with those in the rear part of
the foot. Insert and fasten the screws.
Ensure that the supply cord is fitted through
4
the corresponding opening.
Place on a stable level surface.
5
Warning
• The product may only be connected to
the mains once it has been completely
assembled.
• The product must not be disassembled
during operation, general care, cleaning
and user maintenance.
• The product may never be operated
without the stand or in a horizontal
position.
Operation
Note: The function settings and on/off
switch can operated from the control panel
on the ventilator as well as remotely.
Plug the power plug into the socket. The room
6
temperature is shown in the display.
Turn on the ventilator using the POWER
7
button.
18
IM_KTF121_140930_V03_HR.indb 18
All manuals and user guides at all-guides.com
8
9
10
Timer mode
The TIMER function switches the ventilator off
at a set time. Times can be selected between 1
to 12 hour intervals.
11
Note: If the timer is not activated, the
room temperature in °C will be shown in the
TIMER/TEMP display.
Select the fan strength using the SPEED
button.
Symbol
Select the desired operating mode using the
MODE button.
Mode Function
Standard fan function
Adjustable fan strength, which
simulates natural wind.
Sleep mode, display turns
off automatically approx. 30
seconds after the last use.
Press the OSC button to turn the swivel
function on and off.
Press the TIMER button to set the turn-off
time.
Fan strength
low
medium
high
29/9/14 5:34 PM