Prem-I-Air EH1576 Notice D'utilisation page 3

To assemble the fan;
Remove the fan locking nut (3) and grille locking nut (6) from the motor
•
shaft
Fit the rear grille (5) by positioning the locating pins in the slots on the grille.
•
Secure the grille to the body with the grille lock nut (6)
Push the fan blade (4) onto the motor shaft positioning the slots on the rear
•
of the blades in the shaft pin on the motor shaft.
Secure the fan blades using the fan blade nut (3), noting that the nut has a
•
left handed thread (turn anti-clockwise to tighten).
Open all the securing clips around the front grille (2) and loosen the
•
securing screw.
Line up the screw with the corresponding hole in the rear grille and tighten
•
Line the front grille (2) with the rear grille (5) and press the front grill firmly
•
into position. Close all the clips and tighten the safety screw.
Line up the main pillar (14) with the hole in the base and secure using the
•
pillar nut (17)
Plug the mains lead into a 13 Amp mains socket. If any other appliances are
•
connected to the same extension lead, make sure that it is rated for the total
power of all appliances connected.
If connecting via an extension lead, make sure that the lead is rated at 3
•
Amps or more, and that it is fully unwound.
Switch the appliance on at the mains socket.
•
Use the On/Speed knob (10) to start the fan, Select the desired speed by
•
rotating the knob to positions 1, 2 or 3 for Low, medium and High speed.
The oscillation control (11) allows the unit to oscillate the fan head to cover a
•
greater area.
To switch Off rotate the control knob (10) to the 0/Off position.
•
It is normal for the motor to become warm in normal use.
•
Unplug the appliance from the mains when not in use.
•
At time of going to press, the average cost of electricity is £0.12 per unit (kilowatt-
hour). The amount you are being charged will be shown on your electricity bill. At
this cost, the EH1576 will cost 13p per day to run on the "low speed" setting, or
18p per day to run on the "high speed" setting.
When used in an office environment, we recommend that this product should be
safety-tested yearly by a qualified electrician (PAT Tested).
We recommend that it is PAT tested regularly when used in a domestic
environment.
2841
All manuals and user guides at all-guides.com
OPERATION
OPERATING COSTS
PAT TESTING
3
Ver. 3 - 04/14