Low Battery Signal; Replacing The Battery - Fora W310b Manuel De L'utilisateur

2. Long press SET on the weight scale until PCL displayed on the
screen during the pairing process.
3. On your mobile device, launch the iFORA WS app.
4. Select the Setting label and then tap the Pairing button.
5. Tap the Search button to search for available BLE meters. Wait
for a few seconds, a pop-up window shows up to display the
search results.
6. Select "FORA W310" to start pairing.
7. When pairing is complete, "FORA W310" will be displayed in
the Available BLE Meters field on your device.
8. Tap to pop up the message window. Select Yes to save the
setting.
Data transmission
X
After each measurement, the Bluetooth will be automatically
activated and the weight scale will try to connect to the paired
device (e.g. smart phone) to transmit the data.
Mobile phone compatibility issues
X
The Bluetooth functionality is implemented in different ways by
the various mobile phone manufacturers.
Unfortunately, in some mobile phone models, even with
Bluetooth functionality, they may be compatible only with
certain types of devices. If a problem occurs in the connection
between your mobile phone and the weight scale, or if you are
uncertain regarding your mobile phone's Bluetooth capabilities,
please consult your mobile phone manual or contact your local
customer service for assistance.
Note:
．While the weight scale is in transmission mode, it will be unable
to perform a test. Press SET to return to measuring mode.
All manuals and user guides at all-guides.com
．Make sure your device has the Bluetooth function turned
on and the weight scale is within the receiving range before
transmitting the data.
MAINTENANCE
Your scale takes four 1.5V AAA alkaline batteries.

Low Battery Signal

The scale will display the message shown to alert you when the
scale power is running low. This means it is about time to replace
the battery. (n)
WARNING!
If the incorrect type of battery is used, it may cause damage to
the scale.

Replacing the Battery

When replacing the battery, make sure that the scale is turned off.
1. Press the edge of the battery cover and lift it up.
2. Remove the old batteries and replace them with four 1.5V
alkaline batteries
3. Close the battery cover. (o)
Note:
．Replacing the battery does not affect the test results stored in
memory.
．Properly dispose of the batteries according to your local
environmental regulations.
．Batteries may leak chemicals if left unused for a long time.
Remove the batteries if you are not going to use the device for
EN-4