RAB Design HLS-LED60 Directives D'installation page 2

HLS-LED60
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
When using outdoor use portable luminaires, basic safety precautions should always be followed to reduce the risk of fire, electric
shock, and personal injury, including the following:

Use only three-wire outdoor extension cords that have three-prong grounding plugs and grounding receptacles that
accept the appliance's plug.

Ground Fault Circuit Interrupter (GFCI) protection is to be provided on the circuit(s) or outlet(s) to be used for the wet
location portable luminaire. Receptacles are available having built-in GFCI protection and are able to be used for this
measure of safety.

Use only with an extension cord for outdoor use, such as an extension cord of cord type SEW, SEOW, SEOOW, SOW,
SOOW, STW, STOW, STOOW, SJEW, SJEOW, SJEOOW, SJW, SJOW, SJOOW, SJTW, SJTOW, or SJTOOW.
SAFETY

Proper grounding is required to ensure personal safety.

Do not use this equipment for anything other than its intended purpose.

Servicing this equipment should be performed by qualified service personnel.

SAVE THESE INSTRUCTIONS.

DO NOT SUBMERSE.
INCLUDED PARTS
1. 2x LED Light Heads
2. Handles
3. Locking knobs
4. Extendable Metal stand
PRODUCT SPECIFICATION:
Model
Nominal Voltage
Nominal Freq. (Hz)
Circuit wattage
Rated Maximum Ambient Temperature
IP Rating
INSTALLATION:
The HLS-LED60 is supplied completely assembled, ready for use. Ensure the power cables are unwound and connected to an
authorized grounded receptacle in a dry location. You can adjust the light angle by loosening knobs and tilt to desired position.
Retighten knobs.
RAB DESIGN LIGHTING INC.
READ, UNDERSTAND
before installing the equipment.
HLS-LED60
120V
60Hz
2 X 30W
40°C
IP65 (wet location)
www.rabdesign.ca
FOLLOW
, and these instructions
1