Understanding The Display - GE XPIO13BCBT Manuel D'utilisation

Care and Cleaning
Removal of Mineral Deposits
1. F ill the reservoir with white vinegar to the max fill line and run up to three cleaning cycles. Or
purchase an Opal Cleaning Kit and follow instructions inside.
2. I f using vinegar, leave the vinegar in the unit for 18 hours and set a vinegar-soaked towel on
the ice chute overnight to further dissolve any mineral buildup. See figure 10.
3. Clean the sensors with vinegar and wipe clean with water. After draining the vinegar, run
three rinse cycles, using fresh water for each rinse. See figures 11, 12, and 13 to reference
location of the sensors.
Figure 11
Cleaning the Bin and Tray
To clean the ice bin, remove the ice bin from the ice maker and clean with a soft cloth dampened with soapy water.
Rinse thoroughly. Dry with a soft cloth. Do not use solvents or chemicals.
The drip tray should be wiped dry. Water left in this area may leave deposits. To clean the drip tray, remove the tray
from Opal and use a soft cloth dampened with mild soapy water to gently clean the surface. Dry with a soft cloth. Do
not use solvents or chemicals.

Understanding the display

Power
The Power button, when pressed, will begin the ice
making process. When pressed, while ON, will turn the
ice maker off.
Light
The light feature has three different modes: ON/DIM/OFF.
Toggle between the three modes by pressing the light
button until you reach your desired lighting mode.
Clean
The cleaning cycle is initiated by pressing and holding
49-1000464 Rev. 1
Making Ice Add Water
Defrosting Cleaning
Figure 12
Clean
Hold 3 Sec
the 'Clean' button for three seconds.
Indicator Lights
The four indicator lights on the left-hand side of the unit
display the current status of the Opal. If 'Add Water' is
highlighted, your unit needs more water before it can
cycle to make ice or clean.
WiFi
Using the complimentary Opal mobile app, customers
can connect to their Opal and control it from their Android
or iPhone. The indicator light on the left-hand side will
confirm a successful connection. See page 14 for how to
connect Opal Ice Maker to WiFi Application.
Figure 10
Figure 13
Light Power
9