ElectricSA ESA1001ZB Guide Du Propriétaire page 13

All manuals and user guides at all-guides.com
4. Assemble the shaft. Turn the bike upside down and remove
the front fork protector (picture just for reference, please
make sure the components on the handle bar are all well
protected when you turn the bike down). Taking off the
cap nut and a spring in the shaft. Then pass the shaft
through the front wheel. Put the spring on and then tighten
the cap nut a little bit. Please do not tighten completely the
cap nut because you have to re-loosen it when installing the
front wheel.
5. Secure the front wheel to the front fork. Please keep the
two disc brakes on the same side. Tighten the cap nut and
the clamp.
12