Publicité
5. Meter Description
1.
IR Sensor
2.
LCD Display
3.
SET Key
4.
TC Key
5.
String hole
6.
Probe
7.
IR Key
8.
MODE Key
9.
Battery cover
6. LCD Description
1.
IR reading
2.
TC temperature symbol
TC reading
3.
4.
TC hold symbol
5.
Temperature units
6.
IR hold symbol
7. Operating Instruction
1. Operating steps:
1.1
Point the front of the meter towards the surface to be measured.
1.2
Press"
" button, infra-red temperature appears in the IR Temp area, on the top half of the LCD display.
1.3
Insert the steel probe into the object to be tested. Press"
1.4
Under "HOLD" mode, meter will power off automatically after 3 minutes of no activity
Notes：Under IR mode, TC readings will be held automatically
Under TC mode, IR readings will be held automatically
2．Button Function
2.1
Button: under measuring mode. Press "
2.2
Button: under "HOLD" mode, press"
2.3 Press"
"button, "MAX" appears on the LCD, meter enters into"
2.4 Press"
" button，"MIN" appears on the LCD, meter enters into"
2.5Press"
" button，"LOCK" appears on the LCD, meter enters into"
button
2.6 Press "
", "
" appears on the LCD. Press "
Button: Press "
" button to turn the meter on，press"
2.7
"button to turn the meter on, press TC to take a temperature reading with the penetration probe
2.8
Button: Press"
3．Battery Replacement
3.1 When the low battery icon"
"appears, replace the battery.
3.2 Open the battery compartment, replace the 3V battery and close the battery compartment
8. Notes
1）Field of View
◆
◆
The smaller the target object is, the closer the meter should be to it for accurate measuring.
When accuracy is critical, make sure the target is at least twice as large as the spot size.
As distance (D) from the object increases, the spot size (S) of the area measured by the unit should become larger.
2）Locating a hot spot
◆
To find a hot spot, first aim the thermometer to the outside of target area, then scan across in an up and down motion until the hot spot is located.
3） Notice
7.
Temperature units
8.
Battery symbol
9.
IR continuous measuring
10.
MIN symbol
11.
MAX symbol
12.
IR temperature symbol
"button，TC temperature appears in the TC Temp area on the bottom half of the display.
" button to change the temperature units.
"button，meter enters into
" mode. Press"
" mode. Press"
" mode. This means the meter will continuously take an infra-red temperature without pressing the IR
" to adjust the emissivity value
" button again to take an infra-red reading
STIL - 254 rue Foch – Vaux le pénil – France
step by step, press button again to return to normal measuring mode
" button and only the maximum temperature detected will appear on the display
" button and only the minimum temperature detected will appear on the display
www.stil.fr
Publicité
