AquaScape 84073 Instructions D'installation

I N S T A L L A T I O N
LED COLOR-CHANGING
LIGHTING REMOTE CONTROL
LED Color-Changing Lighting Remote Control
Item #84073
For complete light installation steps and
warranty information, please see the LED
Color-Changing Light instruction manual.
Contents - #84073
No. Description
1. Remote Control
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the follow-
ing two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compli-
ance could void the user's authority to operate the equipment.
Instructions
REMOTE CONTROL PAIRING
• Each control hub includes a wireless remote control. Install two AAA
batteries (not included) in the back of the remote control.
• To synch the remote control to the hub, hold the power button on the
remote while connecting the 2-pin quick-connect fitting on the hub to the
transformer (Ex. 1).
• All lights plugged into the control hub will flash green when paired.
www.graystonecreations.com
706-865-0220
2 1
B B
1
A A
2 1
I N S T R U C T I O N S
REMOTE CONTROL FUNCTIONS
• Power/Pair – Turn lights on and off as desired. Also use this button to pair
the remote to the hub.
• Color Wheel – Select your desired color
• Rate/Speed Up – Increase the speed of the cycle or strobe option
• Rate/Speed Down – Decrease the speed of the cycle or strobe option
• Select Mode – Stops the cycle or strobe to achieve the desired color
• Undo Mode – Revert back to the cycle or strobe last selected
• Brightness Up – Increase the brightness
• Brightness Down – Decrease the brightness
• Cycle – Continuously changes through all available color options
• White – Engages the white diodes for a warm white light (3,000 K)
• Strobe – Engages the strobe setting
Troubleshooting
• Lights won't turn on
– Press the power button on the remote
– Make sure the outlet is receiving power
– Make sure the ground-fault circuit interrupter (GFCI) is not tripped
– Check to verify that the lights are receiving the correct voltage
– Verify that the photocell is functioning properly
• Lights won't turn off
– Verify that the photocell (not included) is functioning properly
• Remote Control is not functioning
– Make sure the AAA batteries are not dead
– Re-synch the remote control to the lighting control hub
Ex. 1
01/19