Functions - Subzero SZ-AI2 Manuel D'utilisation

FUNCTIONS

MIC 1
MIC 1
1
LEFT OUT
LEFT OUT
FRONT PANEL
1. MIC 1
Use this input to connect XLR /TRS devices such
as microphones and line level instruments.
2. GAIN 1
Use this to increase/decrease the amount of
gain on the MIC 1 input.
3. INS 1
Use this button to switch between high (line-
level) and low (microphones) impedance on the
MIC1 input.
4. MIC 2
Use this input to connect XLR /TRS devices such
as microphones and line level instruments.
5. GAIN 2
Use this to increase/decrease the amount of
gain on the MIC 2 input.
6. INS 2
Use this button to switch between high (line-
level) and low (microphones) impedance on the
MIC1 input.
7. +48v
Use this button to apply phantom power when
connecting a condenser microphone.
2 4
GAIN 1
CLIP
GAIN 1
CLIP
INS 1 MIC 2
INS 1 MIC 2
3
RIGHT OUT
RIGHT OUT
12
5 8
MONITOR
MONITOR
GAIN 2
CLIP
GAIN 2
CLIP
INS 2 +48V
INS 2 +48V
6 7
8. MONITOR
Adjust these buttons to switch between stereo/
mono monitoring.
9. MASTER
Adjust this switch to control the master output
volume.
10. HEADPHONE GAIN
Adjust this knob to control the headphone
volume output.
11. HEADPHONE OUTPUT
Use this output to connect your headphones
here.
REAR PANEL
12. LEFT OUT / RIGHT OUT
Use these balanced XLR outputs to connect the
AI2 to either studio monitors, an amplifier, or an
external mixing desk.
13. LOCK CONNECTOR
Use this to connect the AI2 to a laptop lock
connector to prevent the unit from being stolen.
14. USB
Use this port to connect the AI2 to your
computer via the supplied USB cable.
7
9 10
MASTER
MASTER
11
13
USB
USB
14
EN