Completing The Installation - Johnson Outdoors TALON 1810302 Mode D'emploi

Completing the Installation

1
ITEM(S) NEEDED
#20 x 1
NOTICE:
Use the supplied anti-seize on all
fasteners to prevent galling of the nut.
a. Take the Arm Bracket (Item #6) and install it to the
Elbow Bracket. Use two ½"-13 X 4 ¼" Stainless
Steel Bolts (Item #22), four ½" Heavy Duty Stainless
Steel Washers (Item #24) and two ½"-13 Nylock
Nuts (Item #26). Apply anti-sieze (Item #20).
NOTICE:
When installing the Arm Bracket and
the Flag Bracket in the following steps, give
consideration to the final position of the Talon. Minn
Kota recommends installation so that the Talon can
sit as close to the Transom and as high as possible.
This will provide the most clearance and the greatest
amount of vertical and angular adjustability. For
more information on Talon placement, please see the
"Installing the Talon" section of the Owner's Manual
online at minnkotamotors.com.
b. Carefully slide the long C-channel segment of the
Arm Bracket over the keyed Column of the Elbow
Bracket so the teeth on each piece align to the
desired angle.
c. Two of the Bolts will be used to secure the Arm
Bracket to the Elbow Bracket. Secure each Bolt
by placing a washer on each and secure with an
additional washer and Nylock Nuts after they pass
through the Arm Bracket and Elbow Bracket.
NOTICE:
The C-channel segments may be
indexed to create the desired orientation. The
teeth will not allow the joints to index without first
separating the components. To index the joints,
slide the components apart, index to the proper
orientation and then reassemble the joints.
6 | minnkotamotors.com
#22 x 2 #24 x 4 #26x 2 #6 x 1
1b
C-channel C-channel
Elbow Elbow
Bracket Bracket
Shim Shim
1c
Arm Arm
Bracket Bracket
Column Column
Nylock Nylock
Nut Nut
Arm Arm
Bracket Bracket
Heavy Duty Heavy Duty
Stainless Steel Stainless Steel
Washer Washer
Stainless Stainless
Steel Bolt Steel Bolt
©2019 Johnson Outdoors Marine Electronics, Inc.