Section 6 − Maintenance & Troubleshooting; Routine Maintenance; Blowing Out Inside Of Unit - Unitor UWI 400 Mode D'emploi
Masquer les pouces
Voir aussi pour UWI 400:
- Manuel du propriétaire (36 pages) ,
- Mode d'emploi (36 pages) ,
- Manuel d'utilisation (40 pages)
Table des Matières
Publicité
SECTION 6 − MAINTENANCE & TROUBLESHOOTING
6-1. Routine Maintenance
6-2. Blowing Out Inside Of Unit
OM-202 137 Page 26
!
Replace
Damaged Or
Unreadable
Labels
Disconnect power
before maintaining.
3 Months
Repair Or
Replace
Cracked
Cables
6 Months
Blow Out Inside
.
Maintain more often
during severe conditions.
Replace Cracked
Torch Body
Repair Or Replace
Cracked Cables
And Cords
Clean
And
Tighten Weld
Connections
!
Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers as
shown.
ST-801 192
Publicité
Table des Matières
Dépannage
