Tips And Tricks; Operating Notes - Wilfa Power Fuel XL PB1S-P2000 Instructions

EN
The blender will
not start, and the
display is blinking

TIPS AND TRICKS

• When crushing ice, add some water to get a better crushing performance.
• If the ingredients are too dry, the ingredients might not get in good contact
with the knives, so the knives don't get a hold of all the ingredients. Add some
fluid and reduce the speed to a minimum and give the jug a gentle knock to
help the ingredients to get in good contact with the knives.
• Put liquid and soft food before putting in hard food or ice cubes.
• If you like to use hard seeds or other food which is difficult to blend, you
should try to blend these ingredients as they are, without fluid. If the blending
does not work, add fluid in small portions until it blends well.
• For more tips, tricks and recipes go to wilfa.com or our local website.

OPERATING NOTES

• The blender cannot be operated if:
– The jug is not firmly positioned on the base.
– The wheel is turned to speed or preset before the jug is positioned firmly on
the base.
– The jug is removed during operation and put back again.
• You need to turn the wheel back to 0 position and make sure the jug is
positioned firmly on the base. This will reset the blender.
• If the motor is forced to slow down because of food that is too big in size or
if there is not enough liquid in the jug, and if it operates for a long period,
the temperature monitoring system will trigger and stop the operation of
the motor. The red LED will blink at a rate of 2 Hz. In this case, unplug the
blender and leave it in a place with good ventilation to cool down the motor
temperature for 45 minutes. The system will reset and the blender can be
used again.
• During operation, close the lid tightly to avoid scalding due to spraying of hot
liquids.
• Keep hands and utensils out of the container while the motor is running to
prevent the possibility of severe injury and/or damage. The tamper can be
used while the motor is running.
INSTRUCTION MANUAL · POWER BLENDER
The indicator is not set
to 0
12
Turn the wheel so the indicator
is set to 0